AMT Datasouth ACCEL-6300 User Manual page 133

User's Guide
6-16 Solving Problems
Table 6-1. Troubleshooting Guide––continued
Symptom
Selected printer settings change
before printing begins.
Pin-fed forms do not load properly.
Probable Cause/Corrective Action
Application program is over-
riding your settings. Change
printer setup in your applica-
program.
Forms are not loaded properly.
Refer to Loading Paper
section for detailed procedures.
Wrong paper path selected.
Make sure Rear (or Bottom)
paper path is selected.
Print density fine-adjustment
is set too dark. Hold down
Print Density button and re-
adjust the print density.
PH GAP and PFORCE param-
eters on Setup menu are not
set to Auto, or settings are
incorrect. Check settings.
Paper is not taut between trac-
tors or around platen. Reload
paper.