AMT Datasouth ACCEL-6300 User Manual page 135

User's Guide
6-18 Solving Problems
Table 6-1. Troubleshooting Guide––continued
Symptom
Printer leaves blank line after
every print line.
Carriage does not return to left
margin before printing next line.
Printer only prints hexadecimal
numbers.
Printing does not start at far left
print position.
Printer prints on pin-feed paper
perforations.
Printing starts too far down the
page.
Last line(s) on page print on top
of next page.
Probable Cause/Corrective Action
AUTO LF mode on Setup
menu is on. Turn off mode.
LPI setting on Setup menu is
incorrect. Check setting.
AUTO CR mode on Setup
menu is off. Turn on mode.
EMUL parameter is set to
HexMode. Change setting.
LFT MAR setting on Setup
menu is incorrect. Check
setting.
Top-of-form is set incorrectly.
Advance paper until first print
line is under guide lines on
print-line indicator and press
Alt and Set Top buttons.
LENG setting on Setup menu
is incorrect for paper you are
using. Check setting.
AUTO FF mode on Setup menu
is off. Turn on mode.
TOP MAR setting on Setup
menu is incorrect. Check
setting.
LPI, LENG, TOP MAR, or
BOT MAR setting on Setup
menu is incorrect. Check
these settings.