AMT Datasouth ACCEL-6300 User Manual page 134

Table 6-1. Troubleshooting Guide––continued
Symptom
Multipart forms or labels tear
during printing. Or, labels peel
off the backing sheet during
printing.
Printing goes off right side of page.
Lines of text print on top of one
another.
Probable Cause/Corrective Action
Print density fine-adjustment
is set too dark. Hold down
Print Density button and re-
adjust print density.
PH GAP and PFORCE param-
eters on Setup menu are not
set to Auto, or settings are
incorrect. Check settings.
Forms or labels are too thick
to feed around platen. If media
is pin-feed and you have a top-
mounted pull tractor option, or
your printer has bottom-feed
tractors, try feeding forms from
bottom of printer.
WIDTH setting on Setup menu
is incorrect. Check setting.
AUTO LF mode on Setup
menu is off. Turn it on.
Paper is not taut between trac-
tors or around platen. Reload
paper.
Wrong paper path selected.
Check paper path selection.
Solving Problems 6-17
User's Guide