AMT Datasouth ACCEL-6300 User Manual page 137

User's Guide
6-20 Solving Problems
Table 6-1. Troubleshooting Guide––continued
Symptom
Printer ejects cut sheets before
finishing printing on page.
Forms jam in printer while using
demand document mode.
Control panel display goes blank
during printing.
Paper park, demand document
mode, or popup mode does not
operate.
Probable Cause/Corrective Action
PGE END setting on Setup
menu is On. Change setting
to Off.
LENG setting on Setup menu
does not reflect actual length
of page in use. Change setting.
Forms are snagging on print-
head during reverse feed.
Change DEMAND setting to
Tear and try again.
Static shock may have inter-
fered with display. When print
job is finished and printer is
idle, turn printer off, wait five
seconds, and turn printer back
on.
PATH parameter on Setup
menu is set to TopTrac.
Change setting to None.