Adjusting The Footboard Assembly; Angle; Depth - Invacare Pronto M41 Service Manual

SECTION 7—FRONT RIGGINGS/FOOTBOARD

Adjusting the Footboard Assembly

Angle

NOTE: For this procedure, refer to FIGURE 7.8.
1. Loosen the jam nut and set screw located underneath on the backside of the footplate.
2. Adjust the set screw in or out to obtain the desired footboard assembly angle.
3. Thread the jam nut and washer inward until it is flush with the footboard bracket.
4. Securely tighten the jam nut and washer to secure the mounting screw in place.
Bottom View of
Footboard
Set Screw, Washer
and Jam Nut
FIGURE 7.8 Adjusting the Footboard Assembly - Angle

Depth

NOTE: For this procedure, refer to FIGURE 7.9 on page 51.
1. Remove the quick release pin that secures the footboard assembly to the wheelchair
frame.
Make sure the detent balls of the quick-release pin are fully released and beyond the
outer edge of the tube before operating the wheelchair. Otherwise, injury and/or
damage may result.
Keep detent balls clean.
2. Adjust footboard to one of three mounting positions.
3. Install the quick release pin. Make sure the detent balls are engaged with the outer
edge of the tube (Detail "A").
®
Pronto M41
WARNING
50
Footboard
Assembly
Part No 1145724