Invacare® Pronto™ M41 Series with SureStep®
WARNING!
Make sure the detent balls of the quick-release
pin are fully released beyond the outer edge
of the tube before operating the wheelchair.
Otherwise, injury and/or damage may result.
– Keep detent balls clean.
Removing
1. Remove the quick release pin C that secures the
footboard assembly A to the wheelchair frame by
depressing the button while sliding the pin out.
2. Remove the footboard assembly from the wheelchair
frame.
Installing
52
Fig. 5-1 Detail "A"
1. Position the footboard assembly onto the wheelchair
frame so that the mounting hole in the wheelchair
frame D aligns with the desired mounting hole in the
footboard assembly.
2. Install the quick release pin by depressing the button
while sliding the pin in. Ensure that the detent balls B
are engaged with the outer edge of the tube E (Detail
"A").
5.10.2 Adjusting the footboard assembly angle
Tools:
•
5/32" (4 mm) Allen key
•
1/2" (13 mm) open-ended wrench
1. Loosen the jam nut and set screw A located underneath
on the backside of the footplate B.
2. Adjust the set screw in or out to obtain the desired
footboard assembly angle.
1553378-G