Adjusting The Footboard Assembly Angle - Invacare Pronto M41 Series User Manual

WARNING!
Make sure the detent balls of the quick-release
pin are fully released beyond the outer edge
of the tube before operating the wheelchair.
Otherwise, injury and/or damage may result.
– Keep detent balls clean.
Removing
Remove the quick release pin C that secures the footboard
1.
assembly A to the wheelchair frame by depressing the button
while sliding the pin out.
2. Remove the footboard assembly from the wheelchair frame.
Installing
1553378-C
Detail "A"
Adjusting the mobility device to the user's seating posture
1. Position the footboard assembly onto the wheelchair frame so
that the mounting hole in the wheelchair frame D aligns with the
desired mounting hole in the footboard assembly.
2. Install the quick release pin by depressing the button while sliding
the pin in. Ensure that the detent balls B are engaged with the
outer edge of the tube E (Detail "A").

5.8.2 Adjusting the footboard assembly angle

Loosen the jam nut and set screw A located underneath on
1.
the backside of the footplate B.
2. Adjust the set screw in or out to obtain the desired footboard
assembly angle.
3. Thread the jam nut and washer inward until it is flush with the
footboard bracket.
4. Securely tighten the jam nut and washer to secure the mounting
screw in place.
39