SECTION 8—FOOTBOARD ASSEMBLY
Mounting
Hole
Quick
Detent
Release
Ball
Pin
FIGURE 8.1 - REMOVING/INSTALLING THE FOOTBOARD ASSEMBLY
ADJUSTING THE FOOTBOARD ASSEMBLY
ANGLE
NOTE: For this procedure, refer to FIGURE 8.2.
1. Loosen the jam nut and set screw located underneath on the backside of the footplate.
2. Adjust the set screw in or out to obtain the desired footboard assembly angle.
3. Thread the jam nut and washer inward until it is flush with the footboard bracket.
4. Securely tighten the jam nut and washer to secure the mounting screw in place.
FIGURE 8.2 - ADJUSTING THE FOOTBOARD ASSEMBLY - ANGLE
®
™
Pronto
M94
Wheelchair Frame
Footboard
Assembly
DETAIL "A" - BOTTOM VIEW OF
FOOTBOARD
Quick Release Pin
Outer Edge
of Tube
Set Screw, Washer
and Jam Nut
48
Detent Balls
Footboard
Assembly
Part No. 1122145