For Netware 5.X/6 Novell Distributed Print Service (Ndps) - Konica Minolta bizhub 362 User Manual

Setting up network printing
– Printer Number: Specify "255". (Set the number assigned to the
printer (0 to 254) or 255.)
6
Restart this machine (turn the main power off, then on again).
7
Use the NetWare server console to load MONITOR.NLM.
8
Select the connection information and, in the active connection
column, check that the created Pserver is connected.
Reminder
When turning the machine off, then on again with the main power switch,
wait about 10 seconds to turn the machine on after turning it off. The
machine may not operate correctly if it is turned on immediately after
being turned off.

For NetWare 5.x/6 Novell Distributed Print Service (NDPS)

Before specifying settings for NDPS, check that the NDPS broker and NDPS
manager have been created and loaded.
Also, before performing the following procedure, check that the TCP/IP
protocol has been set in the NetWare server, and check that the IP address
has been set for this machine and that this machine is on.
1
Log on to NetWare as an administrator from a client computer.
2
Start up NWadmin.
3
Right-click the organization or organizational unit container where you
will create the printer agent, and then click "NDPS Printer" on the
"Create" sub-menu.
4
In the "NDPS Printer Name" box, enter the printer name.
5
In the "Printer Agent Source" column, select "Create a New Printer
Agent", and then click the [Create] button.
6
Check the printer agent name, and then in the "NDPS Manager Name"
box, browse through the NDPS manager names, and register one.
7
In "Gateway Types", select "Novell Printer Gateway", and then register
it.
bizhub 362/282/222
4
4-31