Configuring Vlan Policy On An Access Interface - Cisco ASR 9000 Series Configuration Manual

Configuring VLAN Policy on an Access Interface

DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2 interface type
Example:
RP/0/RSP0/CPU0:router(config)# interface
Bundle-Ether1.1
Step 3 service-policy output name subscriber-parent
Example:
RP/0/RSP0/CPU0:router(config-if)#
service-policy output svlan
subscriber-parent
Step 4 Use the commit or end command.
Configuring Policy on S-VLAN: An example
configure
interface Bundle-Ether1.1
service-policy output svlan_pmap subscriber-parent
end
!
Configuring VLAN Policy on an Access Interface
Perform this task to apply an ingress and egress QoS VLAN policy on an access interface.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide,
Release 4.3.x
210
Purpose
Enters global configuration mode.
Configures the subscribers on the Bundle-Ether access interface.
Configures the s-vlan policy with the subscriber-parent keyword.
commit—Saves the configuration changes and remains within the
configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the configuration
session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration mode, without
committing the configuration changes.
Deploying the Quality of Service (QoS)
OL-28375-03