Deploying the Quality of Service (QoS)
policy does not provide reference bandwidth to session policies. The VLAN policy statistics does not include
session policy statistics. Only the access-interface traffic is subjected to the VLAN policy.
For details, see
This table summarizes the support for VLAN and S-VLAN policies in ingress and egress directions:
Policy Direction
Ingress
Egress
Restrictions
These restrictions apply to the VLAN policy on the access-interface, when used without the subscriber-parent
keyword:
• The VLAN policy needs to be attached to the access-interfaces, before bringing up the sessions with
• The restrictions specified for the in-place modification of S-VLAN policy, are applicable to VLAN
Configuring Policy on S-VLAN
Perform this task to apply a QoS policy on a S-VLAN.
• S-VLAN policy has to be provisioned before any policies are installed on subscribers.
Note
• Application of S-VLAN policy is rejected, if policies are already installed on subscribers.
• Removal of S-VLAN policy is rejected, if subscriber policies are present under that S-VLAN.
SUMMARY STEPS
1. configure
2. interface type
3. service-policy output name subscriber-parent
4. Use the commit or end command.
OL-28375-03
Configuring VLAN Policy on an Access Interface, on page
QoS policies.
policy as well. For instance, the in-place modification for the VLAN policy supports only rate-changes.
This restriction also applies in adding a policer or shaper and in changing the policy-map to include
more classes.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide, Release
V-LAN policy (without
subscriber-parent keyword)
Supported
Supported
Configuring Policy on S-VLAN
210.
S-VLAN policy(with
subscriber-parent keyword)
Not supported
Supported
4.3.x
209