Configuring The Subnet Number And Mask For An Address Pool - Cisco ASR 9000 Series Configuration Manual

Configuring the Subnet Number and Mask for an Address Pool

Command or Action
Step 6
Use the commit or end command.
Creating a Configuration Pool Submode: An example
configure
pool ipv6 pool1 (default vrf)
!
!
configure
pool vrf vrf1 ipv6 pool1 (for a specific vrf)
!
!
end
Configuring the Subnet Number and Mask for an Address Pool
Perform this task to create the subnet number and mask for an IPv6 address pool.
SUMMARY STEPS
1. configure
2. pool vrf vrf_name ipv6 ipv6-pool-name
3. prefix-length value
4. network subnet
5. utilization-mark high value low value
6. exclude low_ip_address high_ip_address
7. Use the commit or end command.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide,
Release 4.3.x
250
Purpose
commit—Saves the configuration changes and remains within the
configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the configuration
session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration mode, without committing
the configuration changes.
Configuring Subscriber Features
OL-28375-03