Cisco Asr 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide - Cisco ASR 9000 Series Configuration Manual

New and Changed BNG Features
Feature
IPv6 Support on
DAPS
Packet Handling
on Subscriber
Interfaces
Enhancements
OL-28375-03
Description
This feature was supported
on IPv6.
This feature was supported
with enhancements.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide, Release
New and Changed Information
Introduced/Updated Release
Release 4.3.0
Release 4.3.0
Where Documented
Configuring Subscriber
Features chapter:
• DAPS Support, on
page 247
• Configuring the Subnet
Number and Mask for
an Address Pool, on
page 250
• Specifying a Range of
IPv6 Addresses, on
page 252
• Specifying a Utilization
Threshold, on page 253
• Specifying the Length
of the Prefix, on page
255
• Specifying a Set of
Addresses or Prefixes
Inside a Subnet, on
page 256
Refer Address Pool Service
Commands chapter in Cisco
ASR 9000 Series Aggregation
Services Router Broadband
Network Gateway Command
Reference for information on
the commands used for
configuring DAPS.
Establishing Subscriber
Sessions chapter:
• Packet Handling on
Subscriber Interfaces,
on page 170
4.3.x
11