Configuring Igmp Parameters For Subscriber Interfaces - Cisco ASR 9000 Series Configuration Manual

Configuring Subscriber Features
Command or Action
Step 6
show igmp unicast-qos-adjust statistics
Example:
RP/0/RSP0/CPU0:router# show igmp
unicast-qos-adjusted statistics
Step 7 show igmp unicast-qos-adjust statistics interface
interface-name
Example:
RP/0/RSP0/CPU0:router# show igmp
unicast-qos-adjusted statistics interface
interface1
Configuring route-policy for Unicast QoS Shaper: Examples
#Adding a route-policy for profile1
route-policy profile1
if destination in (239.0.0.0/8 le 32) then
set weight 1000
endif
end-policy
# Configuring profile1 for Unicast QoS Shaper
router igmp
vrf vrf1
traffic profile profile1
!
!
end

Configuring IGMP Parameters for Subscriber Interfaces

Perform this task to configure IGMP parameters for subscriber interfaces.
SUMMARY STEPS
1. configure
2. dynamic-template
3. type ppp dynamic-template name
4. igmp explicit-tracking
5. igmp query-interval value
6. igmp query-max-response-time query-response-value
7. Use the commit or end command.
OL-28375-03
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide, Release
IGMP to Unicast QoS Shaper Correlation
Purpose
(Optional) Displays the internal statistics of the feature, such as
total number of interface groups under adjustment, uptime since
last clear command, and total number of rate adjustment calls for
unicast QoS shaper.
(Optional) Displays the interface name, number of flows adjusted,
total rate adjusted, uptime after first adjustment for unicast QoS
shaper.
4.3.x
243