Ipv6 Pppoe Subscriber Support; Configuring Ipv6 Pppoe Subscriber Interfaces - Cisco ASR 9000 Series Configuration Manual

DHCPv6 Features
interface GigabitEthernet0/3/0/0
ipv4 address 11.11.11.2 255.255.255.0
ipv6 address 11:11:11::2/64
ipv6 enable
service-policy type control subscriber dhcpv6_policy
ipsubscriber ipv6 l2-connected
initiator dhcp
!
!
end
end

IPv6 PPPoE Subscriber Support

The PPPoE subscriber interfaces establish a PPP link with the subscriber, which is used for authentication
and address assignment. The DHCPv6 server assigns the address or prefix to the PPPoE subscriber. Because
the PPPoE subscriber interfaces are created dynamically, the DHCPv6 profile is applied to all the PPPoE
interfaces created on the router, and not just a single PPPoE interface.
To enable PPPoE subscriber support, you have to configure the DHCPv6 profile globally or on all PPPoE
interfaces. For more information, see

Configuring IPv6 PPPoE Subscriber Interfaces

Perform this task to configure PPPoE subscriber interfaces.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide,
Release 4.3.x
154
Configuring IPv6 PPPoE Subscriber Interfaces, on page
Establishing Subscriber Sessions
154.
OL-28375-03