Cub Cadet 8354 Service Manual page 229

• Make sure the number of centering
spring is correct, as it is different as
input torque spec. of the product.
CAUTION
5. While raising spool and from sleeve and com-
pressing the opposite end of centering spring by
hand, push spool into the groove of sleeve. This
time, slide insert tool at the same speed of spring
compression. After inserting, align the end of
spring with outer circumference of sleeve.
• Align with position alignment mark
when disassembling.
• Centering spring can be protruded
CAUTION
from spool, so always wear safety
goggle.
6. Insert pin (13) into hole of sleeve and spool and
sleeve assembly into GEROTOR of housing.
• Make sure that spool and sleeve as-
sembly are rotated slightly in housing.
CAUTION
7. Insert driver (11). This time, align with pin (13) and
yoke of driver.
8. Assemble O-ring (31) on gerotor and assemble
GEROTOR rotor into groove.
9. Insert plate (5), O-ring (6) and plate (7) into inside
spline of GEROTOR rotor.
10. Align bolt hole of housing with oil hole using spacer
plate (8).
11. Apply screw (1) with oil and insert into end cap (2).
• Tighten seven screws (1) into about 1.
0 Kgf·m (9.8 N·m, 7.2 lbf·ft) torque in
advance.
CAUTION
D615-W02 May-2003
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
(12) Sleeve
(14) Spring
(11) Driver
STEERING SYSTEM
(15) Spool
[B] Position Alignment Mark
(13) Pin
615W828A
615W829A
8-19