h. Top Link Bracket
a) Disassembly
1. Before disassembling the top link holder assembly,
disassemble the socket support and coupler socket
assembly.
2. Disassemble bolt (13), lock washer (14), roller (15),
and plate (12).
3. Disassemble nut (21).
4. Remove snap ring (11) and then disassemble pin
(10).
5. Disassemble top link bracket (1).
6. Pull out bolt (7), (9), and then disassemble flange
(2).
7. Disassemble cover (3), spring (4), roller (5), and
bolt (6) in the assembly.
b) Assembly
1. Apply bolt (6), and spring (4) with grease sufficiently
when assembling.
•
Don't change the assembled position
of plate when disassembling flange
(2).
CAUTION
•
Make sure top link holder (1) does not
fall to ground when disassembling pin
(10).
•
When assembling bolt (7), check draft
for operation and then repeat assem-
bly several times.
D615-W02 May-2003
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
(10) Pin
(11) Snap Ring
HYDRAULIC SYSTEM
(1) Top Link Holder
(12) Plate
(2) Flange
(13) Bolt
(3) Cover
(14) Lock Washer
(4) Spring
(15) Roller
(5) Roller
(16) Nut
(6) Bolt
(17) Tie Rod
(7) Bolt
(18) Snap Ring
(8) Lock Washer
(19) Crank
(9) Bolt
(20) Pin
(21) Nut
615W939A
9-33