Cub Cadet 8354 Service Manual page 128

CHAPTER 4 8354/8404
B. Second Stage (Hydraulic Pipe Disconnection)
(1) Brake Rod
(2) Intake Pipe 3
(3) Intake Pipe 2
(4) Rubber Pipe
(5) Clamp
(6) Hydraulic Pipe 1
1. Disconnect brake rod (1) from the left and right of
tractor body.
2. Loosen intake pipe 3 (2) and intake pipe 2 (3), con-
necting rubber pipe (4), and clamp (5), Push and
lower the rubber pipe into intake pipe 2 and then
disconnect the connecting part.
3. Loosen bolts (14), (15) and joint bolt (9) of hydrau-
lic pipe 1 (6) and hydraulic pipe 2 (7) and discon-
nect the hydraulic pipe.
4. Disengage bolt (11) of PTO hydraulic pipe (10).
5. Disengage bolts (14), (15) of hydraulic block (12)
and hydraulic block support (13) and disconnect
from clutch housing.
4-24
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
(7) Hydraulic Pipe 2
(8) Bolt
(9) Joint Bolt
(10) PTO Hydraulic Pipe
(11) Bolt
(When reassembling)
• Make sure to clamp connecting rubber pipe of in-
take pipe to prevent air from entered.
• Apply hydraulic pipe connecting O-ring with grease
and take precautions not to do any damage.
Joint bolt
Tightening bolt
(12) Hydraulic Block
(13) Hydraulic Block Support
(14) Washer Holding Bolt
(15) Washer Holding Bolt
(16) Intake Pipe 1
Sect. Spec. Tightening Torque
M18 49.0 ~ 58.8 N·m
5.0 ~ 6.0 kgf·m
36.1 ~ 43.4 lbf·ft
M8 23.6 ~ 27.4 N·m
2.4 ~ 2.8 kgf·m
17.3 ~ 20.2 lbf·ft
M10 23.6 ~ 27.4 N·m
2.4 ~ 2.8 kgf·m
17.3 ~ 20.2 lbf·ft
D615-W02 May-2003
615W439A