Cub Cadet 8354 Service Manual page 143

B. Disassembly of Intermediate Case
a. First Stage (Disconnection of Modulator
Valve Assembly)
1. Disengage modulator valve assembly (1) attaching
bolt (2) and disconnect valve assembly.
(When reassembling)
• Check valve assembly, connecting pipe (3), and O-
ring (4), (5) and apply the contacted surface with
grease.
• Take great care to prevent foreign matters from be-
ing entered inside of valve assembly and connect-
ing pipe.
Sect. Spec.
Tightening bolt, nut M8
b. Second Stage (Disconnection of bearing
over assembly)
1. Disengage bearing cover (1) attaching bolt (2) and
disconnect bearing cover assembly from interme-
diate case.
(When reassembling)
• Take care of assembly position when attaching to
intermediate case with PTO clutch assembly (3) as-
sembled in bearing cover.
• Ensure that protrusion (A) of clutch assembly is lo-
cated between protrusion (B) and (c) of intermedi-
ate case (See the figure below).
Sect. Spec.
Tightening bolt, nut M10
D615-W02 May-2003
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
Tightening Torque
23.5 ~ 27.4 N·m
2.4 ~ 2.8 kgf·m
17.4 ~ 20.2 lbf·ft
Tightening Torque
48.1 ~ 55.9 N·m
4.9 ~ 5.7 kgf·m
35.4 ~ 41.2 lbf·ft
(1) Modulator Valve Assembly
(2) Bolt
(3) Connecting Pipe
(1) Bearing Cover
(1) Bearing Cover
(2) Bolt
(3) PTO Clutch Assembly
TRANSMISSION
615W464A
(4) O-ring
(5) O-ring
615W465A
(2) Bolt
615W466A
4-39