Cub Cadet 8354 Service Manual page 144

CHAPTER 4 8354/8404
c. Third Stage (Disassembly of Shuttle Fork)
1. Straighten cocking of lock washer (1) and loosen
lock bolt (2).
2. Pull out fork rod (4) from bearing cover (3) and dis-
assemble transmission fork (5).
• When disassembling fork rod from
bearing cover, take care of Spring (6)
and Ball (7) not to be bounded.
CAUTION
(When reassembling)
• Insert spring and Ball into bearing cover and as-
semble with groove (A) of fork rod upward.
• Perform cocking of lock washer firmly not to be
loosen after tightened with transmission fork lock
bolt.
Sect. Spec.
Tightening bolt M6
d. Fourth Stage (Disconnection of Gear Shaft
Assembly)
1. Disconnect shuttle shaft assembly (1), 23-21 gear
shaft assembly (2) and 18 gear shaft assembly (3)
from bearing cover (4).
(When reassembling)
• Make sure the assembly position is correct when
assembling gear shaft assembly into bearing cover.
4-40
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
Tightening Torque
9.8 ~ 11.3 N·m
1.0 ~ 1.15 kgf·m
7.2 ~ 8.3 lbf·ft
(1) Lock Washer (5) Transmission Fork
(2) Lock Bolt (6) Spring
(3) Bearing Cover (7) Ball
(4) Fork Rod (8) Shuttle Transmission Arm
(1) Shuttle Shaft Assembly
(2) 23-21 Gear Shaft Assembly
(3) 18 Gear Shaft Assembly
(4) Bearing Cover
615W467A
615W468A
615W469A
D615-W02 May-2003