Cassette 1 Right Door Set Sensor Removal - Epson EPL-N2700 Service Manual

EPSON EPL-N2700 / N2750

4.2.23.7 Cassette 1 Right Door Set Sensor Removal

1. Take out the Cassette 1.
2. Separate the printer. (See Section 4.2.6.)
3. Remove the tension spring hung to the gear (31T).
4. Remove two screws (3704) securing the bracket for the Cassette 1
Control Board to the Cassette 1 Frame, and remove the bracket.
(See Section 4.2.23.5.)
5. Remove one screw (3501) securing the Plate Spring to the bracket
and remove the Plate Spring from the bracket.
6. Remove the following screws:
Two screws (3501) securing the solenoid bracket to the
n
Cassette 1 Frame
Four screws (3704) securing the Paper Take-up Mechanism
n
(Shaft Plate, Guide Plate, and Bracket) to the Cassette 1 Frame
One screw (3501) securing the rail and Shaft Plate
n
7. Lift up the Paper Take-up Mechanism and the solenoid bracket.
8. Remove two screws (3501) securing the Solenoid Bracket to the
Paper Take-up Mechanism and remove the Solenoid Bracket from
the Paper Take-up Mechanism.
9. Remove the stopper fixing the Cassette 1 Right Door Set Sensor to
the Solenoid Bracket.
10. Unhook the Cassette 1 Right Door Set Sensor from the Solenoid
Bracket and remove the Cassette 1 Right Door Set Sensor.
Disassembly/Assembly
11. Remove the harness from the connector on the Cassette 1 Right
Door Set Sensor.
Figure 4-66. Cassette 1 Right Door Set Sensor Removal
Disassembly Procedure
3501
3501
Revision B
139