Epson EPL-N2700 Service Manual page 50

EPSON EPL-N2700 / N2750
Hex-Dump Mode
Converts received data into hexadecimal ASCII codes. Effective all
interfaces.
Button to press: "Form Feed" while turning on the printer
o
Exit: Switch the printer off or perform Warm-boot
o
by job cancel or reset.
EEPROM Initialization
Initializes all controller-side values stored in the EEPROM to factory
default values.
Button to press: "On Line", "Continue", and "Menu" while
o
turning on the printer
C A U T I O N
The Total Counter, Tray Counter, and transfer Roller
Counter, which are managed by the mechanical
controller side, are not initialized.
Panel Setting Initialization
Initializes all panel settings to the factory default values. The printer
performs a warm-boot operation and returns to the normal statues after
the initialization.
Button to press: "Continue" while turning on the printer
o
Exit: Switch the printer off or perform Warm-boot
o
by job cancel or reset.
Product Description
This function initializes all user-selectable settings.
n
C A U T I O N
The values such as total printed pages, toner
n
remaining level, paper remaining level, and all items
printed on an Engine Status Sheet, which are affected
by the printer operation and maintenance operation,
are not cleared.
Formatting the Flash ROM Module
This function erases all contents of the flash ROM module attached to
the DIMM ROM module A slot on the main board.
Button to press:
o
Updating the Program ROM
This function updates the program DIMM in the program socket on the
main board.
Button to press:
o
Copying the ROM Module
This function copies the contents of the ROM module in the socket B on
the main board to the flash ROM module in the socket A. If no ROM
module is in the socket B, the contents of the ROM module in the Code
ROM socket is copied.
Panel Operation
"Alt", "Item", "Value", "Enter"while turning on
the printer
The printer starts initializing when the
message "DIMM A ERASING" appears.
When the job is completed, the printer
performs a warm-boot operation to return to
the normal status.
"On Line", "Alt", and "Value"while turning on
the printer
Revision B
50