Table of Contents
Advertisement
6-2 Search Group
The search function will tune continuously between two (2) selected frequencies in increments of
the currently designated frequency step. By using the Search group function, it automatically
searches frequencies across the pre-selected search groups.
6-2-1 Setting Search Group
Press the
key, then press and hold the
The following screen will appear.
To select a category, rotate the sub dial.
Group:00
A total of 19 (01～19) can be selected. To select the group, use the
(Note: The 00 cannot be selected.)
Delay:2.0s
Duration before resuming search after a signal is received.
Selectable range: 0.0～9.9 (seconds)
To set the delay, use the
Free:OFF
Duration of receiving.
Selectable range: OFF, 01～60 (seconds).
To set the duration, use the
AutoStore:OFF Select auto store on/off.
This function will automatically store an active frequency into memory bank 39.
If memory channels on bank 39 are full, then a frequency will be overwritten.
Link:
Displays search bank of 00～39. To select the search bank, rotate the sub dial
and press the
Return to the Search List screen.
Delete the frequency at the cursor in the PASS Freq. List.
Delete all PASS frequencies from the frequency list.
key or press the
74
key for 2 seconds.
key.
key.
key to deselect.
key.
Advertisement
Table of Contents
