Table of Contents
Advertisement
12. RESET
Should the AR-ALPHA appear to behave strangely, normal operation may be easily regained by
resetting the microprocessor.
Before applying one of the three different levels of reset (RESET, RESET 2, RESET F), first try to turn
off the power switch on the front panel. Leave it off for approximately 30 seconds. Turn the power
switch back on again.
Normal operation should be restored but the last used frequency will be lost, the AR-ALPHA will
display the second-last frequency used.
Should AR-ALPHA still behave strangely, try one of the following reset levels:
A)
RESET
This initializes all parameters in the CONFIGURATION menu panel to factory default.
Turn of the power switch on the front panel. Hold the [3] key and [6] key while powering up AR-ALPHA.
On the left side of the boot up screen you should briefly see "RESET".
B)
RESET 2
This initializes everything except for the memory channels.
Turn of the power switch on the front panel. Hold the [3] key, the [6] key and the [9] key while powering up
AR-ALPHA.
On the left side of the boot up screen you should briefly see "RESET 2".
C)
RESET F
This initializes everything, all the settings and memories you saved will be ERASED.
Turn of the power switch on the front panel. Hold the [3] key, the [6] key, the [9] key and the [MONI] key
while powering up AR-ALPHA.
On the left side of the boot up screen you should briefly see "RESET F".
133
Advertisement
Table of Contents
