Table of Contents
Advertisement
16.4 Software Installation
① Copy the folder "AR-IQ software v.X" ("X" being the version number) from the supplied CD to any
location in your hard drive
② When first run, the software will ask you about the COM port to which the AR-Alpha USB Remote
Control is connected. After the first run, local settings will be saved in the windows registry.
Possible error message, if the COM port number you entered is incorrect
The example screenshot here shows that
COM8 has been assigned for the COM
port.
③ To start the software, double click the file "ar-iq.exe" located inside the folder "AR-IQ software v.X"
Registry keys not GUI editable (advanced users only)
( HKCU\Software\Microtelecom s.r.l.\ar-iq\v1.0\ )
- AGCRiseTime_ms
- AudioLatency
- AutoModeCountry
- LevelBarPos
- MouseWheelReverse
- PowerOffOnExit
- VcomPort
Solution: In order to find out which COM port number Windows
has assigned, check the Device Manager's
(COM&LPT)".
USB Serial port (COM x) will be indicated. (Note: "x" varies
depending on your PC configuration.)
Controls the response of the spike rejection filter (min=5, max=100,
default=25).
Controls the audio buffer length; lower values minimize latency, higher values
are required for slower computers (min=4, max=20, default=9).
Sets the region for automatic mode change (based on tuned frequency).
Accepted values are 0 for USA, 1 for Japan or 2 for Europe.
Controls the level bar position (0=left, 1=center, 2=right).
If set to 1, inverts the mouse wheel rotation effect.
Accepted values are 0, 1.
If set to 1, shuts down the receiver when the program is exited. Accepted
values are 0, 1.
Sets the virtual COM port for CI-V operation (1..255).
149
"Ports
Advertisement
Table of Contents
