Table of Contents
Advertisement
6. Rotate the sub dial to select the communications baud rate.
The selectable parameters are 9600/19200/38400/57600/115200 baud.
7. Press the
key to move the cursor to FLOW (Flow control by the PC).
8. Rotate the sub dial to select flow control on or off.
9. Press the
(Note) SERIAL, SPEED, FLOW may be set independently.
8-4-9 Configure Sleep Timer
The AR-ALPHA has a sleep timer function where the receiver may be programmed to switch off after a
preset time (1 to 98 minutes).
To access the configuration menu, perform the following steps:
(Example: Setting timer for 30 minutes)
1. Press the
2. The timer display will appear on the top right corner of the display.
3. Rotate the sub dial to set the timer to 30 (minutes.)
4. Press the
When the remaining time reaches 10 minutes, the color of timer icon will change to yellow.
When the remaining time reaches 2 minutes, the color of timer icon will change to red.
key to confirm entry.
key, then press the "SLEEP" key.
key to activate the sleep timer.
100
Advertisement
Table of Contents
