Run Mode - Honeywell HEGSA002 User Manual User Manual

3.3 OPERATION, CONTINUED
The following keystroke combinations will return you to the Honeywell logo screen.
Essentially, these commands exit the Run mode and reboot the ULTRAKey firmware:
ALT (hard key) + HOME (soft key)
ALT + CLR + FUNC (all hard keys)
3.4

RUN MODE

The first default user screen (after the Honeywell logo) in RUN mode is shown below.
The LCD displays ULTRAKey OFF-LINE in the status box at the top of the screen until
communication is sent to the MAX1000 controller or received from the MAX1000
controller. This message is also displayed if the ULTRAKey is connected to a MX14
controller or a MXSYS04 subrack with MX128E controller card and communication is lost
between the two devices. The left or right side of the status box can be pressed to
cause the MAX1000 controller to send different lines of status display. The status
messages are programmable in the SETMAX program.
For complete operator information on how to select and control devices, refer to the
MAX1000 CCTV Management System Operators Manual.
When configured hard keys or soft keys are pressed, they will do one or both of the
following.
1. Send one or more key commands to the MAX-1000 MXAT200. The SETMAX
program defines the key commands. There are 999 key commands available.
2. Access another menu of soft keys.
518750-2960
Rev. F
NOTE: The soft keys
(except Home and Back)
can be reprogrammed in the
configuration mode.
8 HEMU001007
10/15/04