Honeywell HEGSA002 User Manual User Manual page 56

3.5 CONFIG MODE, CONTINUED
6. Left click on Settings or press Alt+S on the PC
keyboard.
Left click on Select Device.
a. Select ULTRAKey by pointing to the radio
b. Left click on OK.
7. Left click on Settings or press Alt+S on the PC keyboard.
Left click on Select Path.
a. Select the Disk where the firmware files are located, for example a: if you are
b. Select the Directory (if applicable) where the firmware files are located on the
c. Left click on OK.
518750-2960
Rev. F
button beside ULTRAKey. When selected, it
should appear as shown above.
using the floppy or c: if you copied the files to your hard drive. The disk must be
highlighted in the window.
disk. Note: If you download from the floppy, the files are stored in the root
directory so you will not need to select a directory.
The path you selected is displayed in the Path: field.
42 HEMU001007
10/15/04