Table of Contents
Advertisement
3.5 CONFIG MODE, CONTINUED
c. To add a keystroke command to the listing, press the New Key soft key.
d. Enter a name for the command. Using the soft up and down arrow keys or the
e. To delete a keystroke command from the listing, highlight the key# and name,
f.
g. Press the OK soft key to save programming or press the Cancel soft key to exit
4. To program a Menu Action,
press the Menu soft key
518750-2960
Rev. F
1)
Enter the keystroke command number (1-999).
NOTE: The keystroke command numbers must correspond to the
commands programmed in the MXAT200 controller using the SETMAX
program.
jog control to scroll through the available characters on the keyboard. You can
also use the numeric keypad to enter numbers.
1.
Press Enter.
2.
Perform step a above to select the new command for the hard key.
then press the Del Key soft key. Note: if the key is being used, an error
message is displayed, "Unable to delete key code. Key being used." Press OK
to exit the error message. If the key code has been selected or created during
this programming session, you must save a new selection for the hard key
before you can delete the key action. Exit the programming menus, then re-
enter the hard key programming screen and delete the key action.
To change the name of a keystroke command, press the Edit Name soft key,
enter a new name, and press OK. The new name appears in the listing.
menu without saving. Note: Changes made with the Edit Name, New Key,
and Del Key soft keys do not revert back if cancel is pressed.
31
HEMU001007
10/15/04
Advertisement
Table of Contents
