Programming A Preshot (View); Sending A Camera To A View (Preshot) - Honeywell HEGSA002 User Manual User Manual

3.4 RUN MODE, CONTINUED

3.4.5 Programming a PreShot (View)

NOTE: Access to programming PTZ preset positions may be denied to some operators.
To program a camera VIEW (PTZ position), you must meet the following criteria:
1. A monitor must currently be selected;
2. The monitor must be displaying the desired camera;
3. The desired camera must be a PTZ camera with VIEW (preset) capability
Using the camera PTZ functions, move to the desired position of the new view.
Perform the following procedure to save the desired position.
Press VIEW then SET.
Press the view number (00-99).
NOTE: Usually only the first ten (00-09) views are available to the keyboard operator.

3.4.6 Sending a Camera to a View (PreShot)

To send a camera to a view, the following criteria must be met:
1. A monitor must be selected;
2. The monitor must be displaying the desired camera;
3. The desired camera must have PTZ with View capability.
Press the VIEW key then the view number (00-99).
518750-2960
Rev. F
20 HEMU001007
10/15/04