Table of Contents
Advertisement
3.5 CONFIG MODE, CONTINUED
a. If there are Menus listed, you can select from the listing by highlighting the
b. To add a new menu to the listing,
c. To delete a menu from the listing, highlight the menu name, then press the Del
d. To edit a menu's name, press the Edit Name soft key. Edit the name by
e. To delete a menu action from a hard key, press the Delete Action soft key.
f.
518750-2960
Rev. F
Menu Name. To view more of the listing, press the soft up and down arrow
keys or the soft Pg Up and Pg Dn keys. When the menu is highlighted, press
the Select Action soft key, then the OK soft key.
press the New Menu soft key
1)
Enter the name of the new menu. Use the soft up and down arrow keys to
view more characters. You can also use the numeric keypad for entering
numbers or the AT-keyboard for entering alphanumeric characters. Use
the Bksp and Clear key for keystroke errors.
2)
Press the Enter soft key. The new Menu name appears in the listing.
The new menu automatically gets assign to the hard key you are editing.
Menu soft key. Note: if the menu is being used, an error message is displayed,
"Unable to delete menu. Menu being used." Press OK to exit the error
message. If the menu has been selected or created during this programming
session, you must save a new selection for the hard key before you can delete
the menu. Exit the programming menus, then re-enter the menu programming
screen and delete the menu.
pressing the Bksp key to clear letters from the end of the name, press the clear
key to clear all letters, then add letters using the soft characters on the display or
use the AT-keyboard. Note: you cannot edit the name of the Startup Menu.
Press the OK soft key to save programming. Press the Cancel soft key to exit
programming without saving.
NOTE: Changes made with the Edit Name, New Menu, or Del Menu soft keys
do not revert back if Cancel is pressed.
32
HEMU001007
10/15/04
Advertisement
Table of Contents
