Datapoints; Viewing Datapoints In Manual Mode - Honeywell CENTRALINE EAGLE User Manual

Table of Contents

BASIC OPERATION PROCEDURES

For ...

Setting Datapoints into Manual Mode

Changing Datapoint Values

see also

Viewing Datapoints in Alarm

EN2Z-0971GE51 R0515

Datapoints can be operated by doing any of the following actions:

• Viewing Datapoints in Manual Mode

• Setting Datapoints into Manual Mode

• Changing Datapoint Values

... refer to the following sections and subsections

Datapoints – Viewing Datapoints in Manual Mode

Datapoints – Setting Datapoints into Manual Mode

Alarm List – Viewing Datapoints in Alarm

Purpose

Shows the list of datapoints which are currently in manual mode. Datapoints may

have been set into manual mode either via controller HMI or the EAGLE web

interface.

Procedure

1. In the Home screen, turn the rotate&push button to navigate to and highlight

Main Menu

2. Then push the rotate&push button. The MAIN MENU is displayed.

3. Turn the rotate&push button to navigate to and highlight Points in Manual.

4. Push the rotate&push button.

All datapoints that are currently in manual mode are displayed. The manual

mode is indicated by the Manual command symbol

A datapoint can be set into automatic mode as described in the following.

5. To set a datapoint into automatic mode, turn the rotate&push button to

navigate to and highlight the datapoint.

Viewing Datapoints in Manual Mode

EAGLE CONTROLLER

Datapoints

... on page

Table of Contents