Table of Contents
Advertisement
3.5 CONFIG MODE, CONTINUED
5. To edit a menu, press the Edit Menu soft key. Refer to paragraph 3.5.5 for
programming a menu.
6. Press the OK soft key to save programming.
Press the Cancel soft key to exit programming without saving.
7. To verify the actions of the hard key, press the Execute Actions soft key.
a. Press the hard key on the controller. Verify the MAX key command actions you
8. Continue programming hard keys or press the Quit soft key to exit the Hard Key
Configuration menu.
3.5.4 Check Hardware
The Check Hardware soft key is a diagnostic tool to verify operation of the hard keys, the
jogs and shuttles, and the joystick
Press the Check Hardware soft key. A screen is displayed with a status box for each
control function or hard key on the controller. Press each hard key and operate the
jogs, shuttles, and joystick. Verify the box for each function fills with bars (joystick and
jog/shuttles) or a block appears (hard key) as you perform the function.
To exit the diagnostic screen, press the touch screen anywhere.
518750-2960
Rev. F
programmed occur.
NOTE: The action (key command) must be programmed in the MXAT200
controller.
33
HEMU001007
10/15/04
Advertisement
Table of Contents
