Hardware Configuration - Honeywell HEGSA002 User Manual User Manual

3.5 CONFIG MODE, CONTINUED

3.5.1 Hardware Configuration

Press the Hardware Config soft key to
access the hardware configuration
options.
+Contrast = 29 - press this soft key
to increase the contrast of the LCD
display.
- Contrast = 29 – press this soft key to
decrease the contrast of the LCD
display.
After setting the contrast to the desired
level, press the SAVE soft key.
LCD B/L = 4 – press this soft key to set the LCD backlight intensity. There are four
settings (1, 2, 3, & 4) with 1 being the lowest intensity and 4 being the highest intensity.
Note: this adjustment only applies to board 470502-1030, Rev. A or later.
Calibrate TouchScrn – press this soft
key to calibrate the touchscreen.
Touch the screen using a small
diameter, soft, blunt instrument (such
as a pencil eraser) as stated in the
message to calibrate the screen.
Press the QUIT soft key to exit the
calibration menu without changing the
settings or press the SAVE soft key to
save the settings and exit the calibration
menu. If you select SAVE, a message
(an example is shown to the right) is
displayed showing the new settings.
Press YES to change the settings.
Press NO to exit the calibration menu.
518750-2960
Rev. F
22 HEMU001007
10/15/04