Setup Of The Ac-Cv6T Tabletop Enclosure; Installing The Wall Mount Panel Into A Tabletop Enclosure (Ac-Cv6T) - AMX COLOR ACTIVE VIDEO TOUCH PANEL (G3 FIRMWARE) Instruction Manual

Setup of the AC-CV6T Tabletop Enclosure

The following paragraphs describe the setup procedures for installing the Wall Mount touch panel
into a tabletop enclosure. The enclosure works by encasing an existing AXD-CV6 touch panel and
using a tabletop cable (AXlink/Video) to connect the unit to both a Master Controller and video
sources.
Finishing Instructions for Aluminum AC-CV6T (FG5924-22).
Surface preparation for the Aluminum CV6T is very important.
The unfinished aluminum version of the AC-CV6T is supplied with a sanded,
non-coated aluminum bezel, aluminum panel mounting blocks, and a stainless
steel base enclosure. Please consult a qualified painter for the appropriate
surface treatment compatible with the end users desired topcoat.

Installing the Wall Mount panel into a Tabletop Enclosure (AC-CV6T)

The CV6T enclosure is an optional metallic housing that is used to mount the base CV6 LCD touch
panel onto a horizontally flat surface. The enclosure uses a plastic strain relief to secure the tabletop
cable to the enclosure.
To install Wall Mount touch panels into an AC-CV6T enclosure:
1. Remove the coiled 10-foot (3.05 m) tabletop cable and accessory bag from within the
enclosure.
2. Confirm that all of the included accessories are present in the box. Refer to the Specifications
AC-CV6T Enclosure table on page 4 for content information.
3. Uncoil the cable and thread the non-terminated end of the tabletop cable into the base
enclosure and then out through the rear opening (FIG. 13).
FIG. 13 Threading the tabletop cable through the base enclosure
4. Continue to thread the cable through the strain relief opening until the heat shrink tubing is
located outside of the enclosure. Refer to FIG. 14 for the final position of the strain relief/cable
combo.
6" Color Video Touch Panels
Installation
Base
enclosure
13