Installing The Adtran 600R; Wallmount Installation; Adtran 600R Front; Adtran 600R Back - Hughes HN7700S Installation Manual

Installing the ADTRAN
600R

Wallmount installation

Appendix E • ADTRAN Total Access 600R
100
1037753-0001 Revision A
Figure 83 and Figure 84 show front and back views of the
ADTRAN 600R.
Figure 83: ADTRAN 600R front
Figure 84: ADTRAN 600R back
The ADTRAN 600R may be wallmounted or used in a table-top
position.
The tools required for wallmount installation of the unit are:
• Four #8 x 3/4 inch pan-head wood screws
• Drill and drill bit set
• Flat head screwdriver (medium)
• Two Phillips head screwdrivers (small/medium)
• Wire-wrap gun (optional)
• 25-pair male amphenol cable (customer connection)
• Selected punch-down block and tool
Decide on a location for the unit. The unit needs to be mounted at
or below eye-level so that the LEDs are viewable.
Mount the chassis with LEDs facing to the side or
Note:
down as shown in Figure 85. Do not place them facing up.