Connecting The Cables To A T-1 Transport Device; Powering Up And Observing The Router Leds; Connecting The Cables - Hughes HN7700S Installation Manual

Connecting the cables

to a T-1 transport device
Powering up and
observing the router
LEDs
Chapter 4 • Connecting the HN router to a transport device
16
1037753-0001 Revision A
Figure 6 is a sample illustration of the connections using a
modem transport device.
Figure 6: Connecting the cables
Note: Ensure the modem has been configured properly prior to
connecting the cables.
To connect the T-1 transport:
1. Connect the installer PC to LAN 1 with an Ethernet cable.
2. Use an Ethernet cable connected to the T-1's 10/100 Base T
port to LAN 2 of the HN router.
3. Connect the power cables.
Power up the remote terminal and watch the LEDs for normal
operation, as follows.