Canada Class B Warning; R&Tte (Eu); Telecommunications Standards; Ipos - Hughes HN7700S Installation Manual

Canada Class B warning

Telecommunications
standards
Appendix D • Conformance with standards and directives
96
1037753-0001 Revision A
This Class B digital apparatus complies with Canadian
ICES-003.
Cet appareil numérique de la classe B est conforme á la norme
NMB-003 du Canada.
R&TTE (EU)
This product is within the scope of the EU Radio Equipment and
Telecommunications Terminal Equipment (R&TTE) Directive.
This section explains compliance with the IP over Satellite
standard (IPoS) and FCC Part 68.

IPoS

The Hughes system is compliant with IPoS, ratified by the
Telecommunications Industry Association (TIA-1008), first
published in October 2003 and issued as Revision A in
May 2006.

FCC Part 68

This section applies to the HN7700S only.
Standards to which Conformity is declared: FCC Part 68
Part 68 Compliance -- This equipment (Two-Way Hughes
System: Model Number: HN router) complies with Part 68 of the
FCC rules and requirements adopted by the ACTA. On the rear
panel of this equipment is a label that contains, among other
information, the product part number (P/N) in the format
XXXXXXX-XXXX and an eight digit Electronic Serial Number
(ESN). If requested, this information must be provided to the
Telephone Company.
The Two-Way Hughes system needs to be installed according to
the instructions. Coaxial cables (Rx and Tx) need to be grounded
at the point of entry. A plug and jack used to connect this
equipment to the premises wiring and telephone network must
Figure 82: IPoS symbol