Ringer Equivalence Number (Ren); Discontinuance Of Service; Telephone Company Changes - Hughes HN7700S Installation Manual

Ringer equivalence number

Discontinuance of service

Telephone Company
comply with the applicable FCC Part 68 rules and requirements
adopted by the ACTA. A compliant 26 Gauge telephone cord and
modular plug is provided with this product. It is required to be
terminated with a plug type 605 or a FCC plug type 6 position for
Australia.
CAUTION
To reduce the risk of fire, use only No. 26 AWG or larger UL
Listed or CSA Certified Telecommunication Line Cord.
This section applies to the HN7700S only.
(REN)
The REN is used to determine the number of devices that may be
connected to a telephone line. Excessive RENs on the telephone
line may result in the devices not ringing in response to an
incoming call. In most, but not all areas, the sum of RENs should
not exceed five (5.0). To be certain of the number of devices that
may be connected to the line, as determined by the total RENs,
contact the local Telephone Company. For products approved
after July 23, 2001, the REN for this product is part of the product
identifier that has the format US:5L4DT##B1032021.
The digits represented by the ## are the REN without the decimal
point (e.g., 00 is a REN of 0.0). For earlier products, the REN is
separately shown on the label.
This section applies to the HN7700S only.
If the Two-Way Hughes System causes harm to the telephone
network, the Telephone Company will notify you in advance that
temporary discontinuance of service may be required. But if
advance notice isn't practical, the Telephone Company will notify
the customer as soon as possible. Also, you will be advised of
your right to file a complaint with the FCC if you believe it is
necessary.
If phone service is discontinued and you believe it is due to the
HN7700S terminal, please contact Hughes Customer Care or
your service provider.
This section applies to the HN7700S only.
changes
The Telephone Company may make changes in its facilities,
equipment, operations, or procedures that could affect the
operation of the equipment. If this happens, the Telephone
Appendix D • Conformance with standards and directives
1037753-0001 Revision A
97