Commissioning By Manual Entry; Selecting And Verifying The Nap; Manual Entry - Service Parameters - Hughes HN7700S Installation Manual

Commissioning by
manual entry
Selecting and verifying the
Hughes recommends using the auto selection process. If you are
instructed to commission by manual entry, you must have
required information to complete this process. See Entering and
verifying the configuration parameters on page 34 for this
information.
Follow the procedures from the beginning of this chapter until
you are requested to select the NAP as illustrated in Figure 26.
On the Service Parameters screen, enter data as follows.
NAP
Figure 26: Manual entry - Service Parameters
1. Click the down arrow for the Service: box.
2. Click to select the NAP from the list.
3. Click the checkbox to select Enter service parameter
manually field.
4. Click the down arrow for the WAN Type field.
5. Click to select the WAN Type from the list.
6. Click Next.
Chapter 5 • Commissioning the HN router
1037753-0001 Revision A
33