Assembling And Connecting The Hn Router Hardware; Attaching The Base; Removing The Base; Chapter 3 - Hughes HN7700S Installation Manual

Attaching the base

Removing the base

Chapter 3 • Assembling and connecting the HN router hardware
10
1037753-0001 Revision A
To attach the base to the router:
1. Position the router and pedestal base Figure 3.
Figure 3: Attaching the router to the pedestal base
2. Starting with the router bottom about ½ inch from the bottom
of the pedestal base, slide the router into the base until the
router locks into position.
If you need to remove the router from the pedestal base:
1. Pull the release tab on the bottom of the base down. (See
Figure 3.)
2. Slide the base away from the router.