Connecting A Dc/Dc Power Supply; Dc/Dc Power Supply - Hughes HN7700S Installation Manual

Connecting a DC/DC power
Figure 5 shows the DC/DC power supply used with the HN
router.
supply
Figure 5: DC/DC power supply
Connect the DC/DC power supply as follows:
1. Connect the DC power cord to the DC IN port on the HN
router.
2. Assemble the input power cable according to the wiring
diagram included in the cable kit.
Note: The input cable kit is included in the power supply
kit. The cable kit contains an input power connector,
connector pins, and a wiring diagram; it does not include wire.
Connect the input power cable to the DC power source, but do not
connect the input power connector to the power supply at this
time.
Chapter 3 • Assembling and connecting the HN router hardware
1037753-0001 Revision A
13