Connecting The Hn Router; Auto Selection - Confirmation Screen - Hughes HN7700S Installation Manual

Connecting the HN
router
Figure 23: Auto selection - Confirmation screen
During the commissioning process the screen displays the
progress of saving the configuration to the local configuration file
and indicates when processing is finished.
To complete the setup process, connect the broadband transport
device to the HN router and the NAP.
• Connect the yellow cable from the transport device to the
LAN2 port on the HN router.
• Connect the laptop to the LAN1 port on the HN router.
• Click the Restart button.
Once the HN router comes back up, it is operating in Router
Mode.
The SCC Home page IP address changes from 192.168.0.1 to
192.168.5.1.
Access the SCC Home Page by opening your Web browser and
typing 192.168.5.1 in the address bar. The system displays the
HN router home page as shown in Figure 24 on page 32.
Note: When commissioned as a router, HN7700S-R is used to
identify this functionality on all user interface screens.
Chapter 5 • Commissioning the HN router
1037753-0001 Revision A
31