Preparing The Hn Router For Installation; Items Required For Installation; Chapter 2 - Hughes HN7700S Installation Manual

Preparing the HN router for installation

Items required for
installation
This chapter discusses preparations you must make prior to
installing the HN router and information you should know before
beginning the installation.
Note: Install your trasport device before installing the HN router.
The appendices listed below give the installation instructions for
the trasport devices.
• Appendix E - ADTRAN Total Access 600R, on page 99
• Appendix F - Siemens 4100/4101 DSL Modem, on page 117
This chapter discusses the following tasks:
• Items required for installation on page 5
• Confirming installer PC and site requirements on page 6
• Customer site requirements on page 7
The HN router and the transport device shipping cartons contain
the equipment necessary for installation. Before beginning the
installation make sure you have all of the items shown in Figure 2
on page 6 and any other materials you may need.
Note: Customers who purchased their system from a Hughes
retail channel receive an order confirmation e-mail.
Note: If the site has a DC power source, it will require a DC/DC
Table 2 on page 11
power supply. See
wire required to assemble the DC input power cable.
Chapter 2 • Preparing the HN router for installation

Chapter 2

. You must provide the
1037753-0001 Revision A
5