Updating The Fallback.bin File; Entering The Router's Ip Address - Hughes HN7700S Installation Manual

Updating the
fallback.bin file
Appendix B • Updating the router software
86
1037753-0001 Revision A
7. Select
Use the following IP address
8. Type
192.168.0.2
9. Type
255.255.255.252
Note: You do not need to enter information in the Default
gateway, Preferred DNS server, or Alternate DNS server
fields.
10. Click OK.
11. Restart the computer even if Windows does not require you to
do so. This ensures that the network settings are
automatically reset.
Follow the steps below to update the
this process, the files containing the current software release are
transferred to the router, overwriting the older files.
1. Confirm that your laptop Ethernet cable is connected to the
router by performing a ping test:
a. Open a DOS command window on the installer laptop PC.
b. Type
ping 192.168.0.1
c. Press E .
NTER
If the ping test is successful, continue with step 2. If the ping
test fails, refer to Troubleshooting on page 87.
2. Navigate to the location on the laptop where you previously
saved the Fallback Updater utility and its supporting files in
Step 4 of Saving the utility on the installer laptop on page 77.
3. Launch the Fallback Updater utility by opening the
hughes_updater.exe
4. Type
192.168.0.1
Updater window as shown in Figure 78. This is the router's
IP address.
Figure 78: Entering the router's IP address
5. Click OK.
During the update process, status messages will appear in the
message window between the address field and the OK button.
.
in the field.
IP address
in the
Subnet mask
fallback.bin
.
file.
in the IP address field on the Fallback
field.
file. During