Starting Kx-Taw848 Maintenance Console - Panasonic KX-TAW848 Features Manual

Starting KX-TAW848 Maintenance Console

Note
The screenshots shown here are for reference only, and may differ from the screens displayed on your
PC.
1. Connect the PC to the PBX with a USB cable.
2. Start KX-TAW848 Maintenance Console from the Start
menu.
3. Enter a valid programmer code (INSTALLER, ADMIN, or
USER), then click [OK].
Note
When starting KX-TAW848 Maintenance Console for
the first time (i.e., either when the PBX is still set to the
factory default settings, or after initializing the PBX),
Quick Setup can be launched automatically by
entering the Installer Level Programmer Code and
password. (→ 2.3.3 Quick Setup)
4. Click "Connect" → "USB" from the menu bar.
Note
To connect to the PBX via USB, the KX-TDA USB
driver must be installed on the PC, as explained above
in "Installing KX-TAW848 Maintenance Console".
5. Enter the password appropriate to the programmer code
entered in Step 3 and click [OK].
Note
The password for each programmer code is 1234 by
default. (→ 2.3.1 PC Programming)
3.2 PC Programming
Feature Guide 203