The Rip Screen - ZyXEL Communications SBG3500-N000 User Manual

Table 41 Policy Forwarding: Add/Edit (Sheet 2 of 2)
LABEL
Source Subnet
Mask
Protocol
Source Port
Source MAC
Destination IP
Destination
Subnet Mask
Destination Port Enter the destination port.
Destination
MAC
WAN
Apply
Cancel

9.4 The RIP Screen

Routing Information Protocol (RIP, RFC 1058 and RFC 1389) allows a device to exchange routing
information with other routers.
Click Network Setting > Routing > RIP to open the RIP screen.
Figure 65 RIP
The following table describes the labels in this screen.
Table 42 Network Setting > Routing > RIP
LABEL
#
Interface
Version
Operation
SBG3500-N000 User's Guide
DESCRIPTION
Enter the source subnet mask address.
Select the transport layer protocol (TCP or UDP).
Enter the source port number.
Enter the source MAC address.
Enter the destination IP address.
Enter the destination subnet mask address.
Enter the destination MAC address.
Select a WAN interface through which the traffic is sent. You must have the WAN
interface(s) already configured in the Broadband screens.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
DESCRIPTION
This is the index number of the entry.
This is the name of the interface in which the RIP setting is used.
The RIP version controls the format and the broadcasting method of the RIP packets that
the Device sends (it recognizes both formats when receiving). RIP version 1 is universally
supported but RIP version 2 carries more information. RIP version 1 is probably adequate
for most networks, unless you have an unusual network topology.
Select Passive to have the Device update the routing table based on the RIP packets
received from neighbors but not advertise its route information to other routers in this
interface.
Select Active to have the Device advertise its route information and also listen for routing
updates from neighboring routers.
Chapter 9 Routing
187