The Rip Screen - ZyXEL Communications XMG3512-B10A User Manual

9.5.1 The RIP Screen

Click Network Setting > Routing > RIP to open the RIP screen.
Figure 66 RIP
The following table describes the labels in this screen.
Table 43 RIP
LABEL
#
Interface
Version
Operation
Enable
Disable Default
Gateway
Apply
Cancel
Chapter 9 Routing
DESCRIPTION
This is the index of the interface in which the RIP setting is used.
This is the name of the interface in which the RIP setting is used.
The RIP version controls the format and the broadcasting method of the RIP packets that the
XMG sends (it recognizes both formats when receiving). RIP version 1 is universally supported but
RIP version 2 carries more information. RIP version 1 is probably adequate for most networks,
unless you have an unusual network topology.
Select Passive to have the XMG update the routing table based on the RIP packets received
from neighbors but not advertise its route information to other routers in this interface.
Select Active to have the XMG advertise its route information and also listen for routing updates
from neighboring routers.
Select the check box to activate the settings.
Select the check box to set the XMG to not send the route information to the default gateway.
Click Apply to save your changes back to the XMG.
Click Cancel to restore your previously saved settings.
XMG3512-B10A User's Guide
131