Table of Contents
Advertisement
Table 8 Routing Mode (continued)
LABEL
802.1q
QoS
Rate Limit
MTU
MTU Size
Apply
Cancel
6.2.1.2 Bridge Mode
Click the Add new WAN Interface in the Network Setting > Broadband screen or the Edit icon
next to the connection you want to configure. Select Bridge as the encapsulation mode. The screen
varies depending on the interface type you select.
If you select ADSL/VDSL over PTM as the interface type, the following screen appears.
Figure 24 Bridge Mode (ADSL/VDSL over PTM)
The following table describes the fields in this screen.
Table 9 Bridge Mode (ADSL/VDSL over PTM)
LABEL
General
Active
Name
Type
SBG3500-N000 User's Guide
DESCRIPTION
Type the VLAN ID number (from 1 to 4094) for traffic through this connection.
Enter the rate limit for the connection. This is the maximum transmission rate allowed for
traffic on this connection.
Enter the MTU (Maximum Transfer Unit) size for this traffic.
Click Apply to save your changes back to the SBG3500-N.
Click Cancel to exit this screen without saving.
DESCRIPTION
Select this to activate the WAN configuration settings.
Enter a service name of the connection.
Select ADSL/VDSL over PTM as the interface that you want to configure. The SBG3500-N
uses the VDSL technology for data transmission over the DSL port.
Chapter 6 Broadband
113
Advertisement
Table of Contents
Troubleshooting
