ZyXEL Communications SBG3500-N000 User Manual page 142

Chapter 7 Wireless
The following table describes the fields in this screen.
Table 25 More AP: Edit
LABEL
Wireless Network Setup
Wireless
Passphrase
Type
Passphrase Key
Wireless Network Settings
Wireless
Network Name
(SSID)
Hide SSID
Client Isolation
MBSSID/LAN
Isolation
Enhanced
Multicast
Forwarding
BSSID
Maximum
Bandwidth
Security Level
Security Mode
Apply
Cancel
142
DESCRIPTION
You can Enable or Disable the wireless LAN in this field.
If you set security for the wireless LAN and have the Device generate a password, the
setting in this field determines how the Device generates the password.
Select None to set the Device's password generation to not be based on a passphrase.
Select Fixed to use a 16 character passphrase for generating a password.
Select Variable to use a 16 to 63 character passphrase for generating a password.
For a fixed type passphrase enter 16 alphanumeric characters (0-9, A-Z, with no spaces). It
must contain both letters and numbers and is case-sensitive.
For a variable type passphrase enter 16 to 63 alphanumeric characters (0-9, A-Z, with no
spaces). It must contain both letters and numbers and is case-sensitive.
The SSID (Service Set IDentity) identifies the service set with which a wireless device is
associated. Wireless devices associating to the access point (AP) must have the same SSID.
Enter a descriptive name (up to 32 English keyboard characters) for the wireless LAN.
Select this check box to hide the SSID in the outgoing beacon frame so a station cannot
obtain the SSID through scanning using a site survey tool.
Select this to keep the wireless clients in this SSID from communicating with each other.
Select this to keep the wireless clients in this SSID from communicating with clients in other
SSIDs or LAN devices.
Select this check box to allow the Device to convert wireless multicast traffic into wireless
unicast traffic.
This shows the MAC address of the wireless interface on the Device when wireless LAN is
enabled.
Specify the maximum rate for wireless traffic in kilobits per second (Kbps).
Select Basic (WEP) or More Secure (WPA(2)-PSK, WPA(2)) to add security on this
wireless network. The wireless clients which want to associate to this network must have
same wireless security settings as the Device. After you select to use a security, additional
options appears in this screen.
Or you can select No Security to allow any client to associate this network without any data
encryption or authentication.
See Section 7.2.1 on page 136
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
for more details about this field.
SBG3500-N000 User's Guide